Hardware

Hi,

I have IBM TS3200 Fibre library and I’m having problems to connect it to my solaris 10 (and TSM) there is nothing in under /dev/rmt ??

Information:
SunOS tsm 5.10 Generic_118833-36 sun4u sparc SUNW,Sun-Fire-280R

HBA Model : QLA2310
Driver Version : qlc-20080514-2.28
FCode Version : 1.14.09
Firmware Version : 3.03.27 IP

There are 2 drivers and one changer and bout are seen by hardware:
cfgadm -o show_FCP_dev -al
Ap_Id Type Receptacle Occupant Condition
c3 fc-fabric connected configured unknown
c3::2002000e11116daf,0 tape connected configured unknown
c3::2002000e11116daf,1 med-changer connected configured unknown
c3::2008000e11116daf,0 tape connected configured unknown
c3::500601603a201211,0 disk connected configured unknown
c3::500601603a201211,1 disk connected configured unknown
c4 fc-private connected configured unknown
c4::210000203784c0ff,0 disk connected configured unknown
c4::210000203784dff0,0 disk connected configured unknown

I have installed the IBMtape as in IBM documentation is instructed.

All commended out in st.conf, mt.conf and lb.conf.
st driver is not loadet. (rem_drv st)

there is in /devices entrys like this: (du -a /devices)
2 /devices/pci@8,700000/SUNW,qlc@2/fp@0,0/sgen@w2002000e11116daf,1
0 /devices/pci@8,700000/SUNW,qlc@2/fp@0,0/sgen@w2002000e11116daf,1:changer

What is sgen@??

So the hardware sees the library but the os dos not compute… any idea how to get the drivers working and something under /dev/rmt?