Oracle VM 2.2.1 VLAN and Cisco Switch
Hi,
I'm trying to configure VLAN access on my Oracle VM 2.2.1 server. When I configure bonding for eth0 and eth1, it works fine. However, when I configure VLAN on the server I lose network connectivity and my switch port often goes into "err disabled".
I have worked with Oracle Support on my VM configuration, and it seems to be OK. The notes followed from Oracle Support are:
Configuration of Network (NIC) Bonding in Oracle VM for x86 [ID 738269.1]
and
Enabling Bonded Virtual LANs (VLAN) in Oracle VM [ID 746103.1]
Oracle support says it is a problem with my switch configuration, so I'm wondering if anyone has any insight into how to configure a Cisco Catalyst 3012 correctly for VLAN use on Oracle VM.
This is a snippet of my switch config: (port 0/4 is the one i'm working on)
#show int status
Port Name Status Vlan Duplex Speed Type
Gi0/1 OracleVM1 connected 207 a-full a-1000 1000BaseX
Gi0/2 OracleVM2 connected 207 a-full a-1000 1000BaseX
Gi0/3 OracleVM3 connected 207 a-full a-1000 1000BaseX
Gi0/4 OracleVM4 connected trunk a-full a-1000 1000BaseX
!
interface GigabitEthernet0/4
description OracleVM4
switchport trunk native vlan 207
switchport trunk allowed vlan 105,107,207
switchport mode trunk
flowcontrol receive on
spanning-tree portfast trunk
Any insight would be appreciated.
Thanks!
Jens