I was using the Strip command for OJET this evening and could strip, restore the content of a web-application without any problems (I could bring the server up after the restore, just as if I had not stripped at all). So there MAY NOT have been an error in the process (prima-facie).
But one observation that causes a concern is that after the strip command, an error message flashes. Here is the error:
Error: Your JET project does not have oraclejet-tooling installed.
Now, should I consider that the strip is successful because the server could be restored or should I take this error message seriously? Does OJET make some logs somewhere on the filesystem so that I can tune the verbosity of the logs and get to the bottom of the observation? I have not seen any --verbose option on the OJET documentation.
Regards
Rahul