Hardware

Hi all, just joined!

We've got a StorEdge 3510 set up as a DAS (private loop mode) connected to three servers. We've gone through hell and high water getting things configured (firmware upgrades were particularly troublesome), but now that we've got everything running, we're starting to think about future expansion. However, despite my experimentation, I can't work out how to set them up in a switched fabric.

We have a test 3510 set up as Point-to-Point, connected to an Emulex 355 FC switch. In Loop mode, the device shows up as a SCSI device, but I can't get Windows to see anything on the end of the HBA when it's in PTP. Half the time, the HBA won't even acknowledge a link.

I can't work out where to start with this. The switch, admittedly, came from Apple with an Xserve RAID, but we've had the 3510 plugged into it in Loop mode and visible, so I don't think there's any problem with Apple ROM-ing the switch.

I've tried Zoning the switch, and Smart-Setting the ports to be Switched Fabrics, but nothing seems to make the StorEdge visible to the host. I thought that the test box might be at fault initially, since it has a Dell-EMC FC HBA and it wouldn't surprise me if it's ROM'd to EMC boxes only, but it seems that another box with a generic QLogic card won't see the StorEdge either.

Full tech specs of the system:
-3510 dual-controller, firmware 4.23A, 12 146GB 10K disks
-Emulex 355 12-port FC SAN Switch
-Dell PowerEdge 1850 with Emulex LP1050Ex-E PCI-E HBA
-Dell PowerEdge 2850 with QLogic QLA210 PCI HBA
-Windows Server 2003 x64

Any advice or starting points would be massively appreciated!
Thanks,
Rob